We offer a plug and play kit for cars with 6HP gearbox. There are no modifications required to the car except for fitting 8HP transmission and TCU.
*This wiring harness do not fit cars factory-equipped with a manual gearbox.
Additionally you are required to connect provided green plug into gear shift level.
Manual cars connection. #
Applies to N43, N51, N52, N53, N54: #
X60001 ECU connector
| ECU pin | TCU plug | Description |
|---|---|---|
| 1 | 66 | Engine CAN Low |
| 14 | 67 | Engine CAN High |
X60002 ECU connector
| ECU pin | TCU plug | Description |
|---|---|---|
| 1 | 35 | Igntion |
X60003 ECU connector
| ECU pin | TCU plug | Description |
|---|---|---|
| 1 | 51-53 | +12V Battery |
Applies to N55: #
X60001 ECU connector
| ECU pin | TCU plug | Description |
|---|---|---|
| 7 | 66 | Engine CAN Low |
| 8 | 67 | Engine CAN High |
| 46 | 35 | Ignition |
Applies to all: #
CAS (must be coded to automatic)
| CAS pin | TCU plug | Description |
|---|---|---|
| 11 | 42 (Aux 8) | Selector lock signal |
| 41 | 56 (Aux 11) | Neutral |
TunerPro configuration #
Start by reading about Tuner Pro setup
If your car was auto before set CAN1 to 30, if not set it to the shifter you are using: List of supported CAN shifters
Set CAN2 to 30
Set Torque Calculation -> Torque Calculation Input to “1”
